Barton 224 dp unit

The Barton Model 224 Differential Pressure Unit (DPU) is a mechanical device that monitors the parallel differential stress of a gas or liquid passing through a process system or the quantity of liquid stored in a process tank. In the factory-stream measurement process scheme, the DPU is linked to a main unit (e.g., venturi, orifice screen, or flow tube). For liquid concentration readings, the DPU can be linked in a multitude of respects to assess the range of stress induced by fluid density differences in the unit ship.
The Barton Model 224 DPU is accessible in separate stress scores to evaluate particular distances between 0-30 inches of water column and 0-1000 psi, with secure work stress (SWP) outcomes of 500 to 10,000 psi (224 Non-C restricted to 500 to 3,000 psi SWP). Table 1-1, point 4. The 224C Bellows Unit Assembly (BUA) is manufactured in three bellow sizes: 1-5/8 inch, 5/8 inch and 3/4 inch. Diameter 1-5/8 inch BUA can handle differential pressure up to 55 psi. The scope springs of this BUA are placed inside the bellows and do not touch the weighed liquid. The 3/4-inch BUA can handle pressure up to 400 psi and 5/8-inch BUA up to 1,000 psi. The area tubes of these BUAs are clustered around the bellows.
If you need a different model other than those listed, please contact us at
224 l 224C



Barton 224 dp unit

Barton Model 224 DPU is a dual bellows tool in load housings. The dual bellows configuration comprises of two inverse fluid-filled bellows, center block, coil springs, overrange valves, and torque tube installation. The stress housings are linked to the main unit in the scheme by pipe or tube. Differential pressure differences within power housings trigger the bellows to grow or divide towards the bottom with the smallest pressure in a circular path. When transferred to the torque tube engine by the spin wheel, the linear motion of the bellows is transformed into angular rotation, and this mechanical movement activates the monitoring system system.

The process monitoring tool associated with torque tube installation may be an indicator, button, receiver, camera, or other process control unit. The M224 DPU tests surface stress (DP) in a method system compared to method tasks and generates a mechanical signal operating on process monitoring tools and method power devices. High-pressure (HP) shipping is linked to the main high-pressure unit by pipe or tube. Low-pressure (LP) conservation is linked to the main low-pressure palm unit.


    • Over 50 years of industry knowledge
    • Fast customer service; response within 15 minutes
    • Best price quality ratio
    • We facilitate the total procurement, purchase and engineering process of our customers