RMG 914 Test Valve

The RMG 372 gas pressure regulator consists of the main valve body on one side and the operating control and safety shut-offs on the other. According to the diaphragm, the final regulation component of the main valve is at the same pressure level. Different diameters of the seat of the valve are open. The purpose of the gas pressure regulator is to monitor the tension in the outlet side of the tube–within certain predefined limits–and to compensate for adjustments in gas consumption and/or inlet stress. There are also a range of multi-size actuators available. Depending on the output level, a pilot may be supplied with or without a separately adjustable auxiliary pressure stage. The pressure difference between the inlet pressure pu and the outlet pressure pd gives auxiliary power to the actuator. Change the auxiliary power to change the stationary amplification by changing the fuel pressure regulator to the

RMG 201 is used at manufacturing stations. This applies to small flow rate control lines in gas pressure control stations. It is ideal for natural gas, gas, etc. G260, and all other non-corrosive substances. The device can also be used in immediate-acting, two-stage procedure, proper for high-pressure drops and comes with a safety pressure release valve for gas discharge in the intermediate-pressure stage. RMG 201 which is easy to operate, control and maintain. The RMG 201 gas pressure regulator was designed to keep the outlet pressure steady within the specified limits, irrespective of inlet pressure and/or stream deviations. The gas pressure regulator consists of two levels of development. The effect of the inlet pressure on the outlet pressure controlling precision is largely limited by the intermediate pressure level. The set-point of the intermediate stage of the pressure is adjustable. The diaphragm of the intermediate stage is filled with the

The RMG 408 gas pressure regulator consists of the actuator board, the working “command unit” and the “SAV” toggle. The control unit is composed of an actuator and an actuator and the filter regulator is connected. After the screws are loosened, the working modules can be separated from the actuator shell. This includes a separate maintenance facility. At the measurement location, the starting point for pressure reduction is recorded and fed to the operator via a measuring sequence. The diaphragm in the controller 7 senses the actual value of the output pressure and compares it to the value of the spring force defined (adjustable comparison variable). In this example, the opening of the actuator to adjust the production pressure (actual value) is adjusted by changing the pressure changes to the optimum value of the regulation deviations. The device shuts down safely with no usage. The actuator is fitted with

RMG 200 Gas Pressure Regulator supplied by RMG is built for municipal, and individual consumers. RMG 200 regulator is suitable as regulator for low rate gas reduction stations . Additionally, the unit is applicable for outlet pressure control, inlet pressure control, outlet and differential pressure control. RMG 200 has a simple construction and it is easily maintained. Various orifices sizes available for order. The unit is suitable for high pressure cuts and operated by high quality pilot series RMG 610 (RS 10 d) and RMG 650. If you need a different model other than those listed, please contact us at contact@ittcontrols.com. 300 l 300 t RMG