RMG 214 Pressure Reducing Valve

The RMG 610 is one of the SERIE 600 Gas Pressure Regulator Pilot Units. In the RMG 610 unit, the flow control valve begins with the inlet pipe dia. The DN 200 and upwards are designed for axial flow and therefore the protection shut-off valve can not be used. The approved valve sleeve system is used to provide full relief of inlet and outlet pressure. The valve closure in the valve cone guarantees a bubble-tight shut-off of the process. The electronic actuator rotates the valve sleeve by rotating the worm wheel, which then turns the sleeve with the gear wheel connected to the valve sleeve. If you need a different model other than those listed, please contact us at contact@ittcontrols.com. RMG

RMG 213 pressure regulator stress-reducing systems minimise the up-stream stress of the gaseous media down to the rear tension adjusted in the rear pressure array. The change of the marginal stress is accomplished by means of a spring-loading of the calculating and working diaphragm. Reducing valves are equipped with screw-in pressure gauges for inlet and rear pressure measurements. Configuration A non-return valve is necessary (return flow safety measure) which prevents the return flow of gas if the inlet pressure drops below that of the back pressure. The bodies of the RMG 213 pressure regulator systems are available in brass or stainless steel for threaded attachment and in cast metal or stainless steel for welding connection. The covers of the measuring devices M, H and S are constructed of pressed brass. As far as the measuring devices G and GS are concerned, the portion of the cover in contact with the gas

The gas pressure regulator RMG 300 is suitable for systems requiring dynamic control (furnaces for steam). The unit is also ideal for natural gas and all fuel systems that are non-aggressive. The unit has a broad input pressure array and an external or internal measuring device. Thanks to its interchangeable operational components, the actuator has high stress compensation and easy maintenance. The control system can also be attached to the device. If you need a different model other than those listed, please contact us at contact@ittcontrols.com. 512b l 512.c RMG

RMG 201 is used at manufacturing stations. This applies to small flow rate control lines in gas pressure control stations. It is ideal for natural gas, gas, etc. G260, and all other non-corrosive substances. The device can also be used in immediate-acting, two-stage procedure, proper for high-pressure drops and comes with a safety pressure release valve for gas discharge in the intermediate-pressure stage. RMG 201 which is easy to operate, control and maintain. The RMG 201 gas pressure regulator was designed to keep the outlet pressure steady within the specified limits, irrespective of inlet pressure and/or stream deviations. The gas pressure regulator consists of two levels of development. The effect of the inlet pressure on the outlet pressure controlling precision is largely limited by the intermediate pressure level. The set-point of the intermediate stage of the pressure is adjustable. The diaphragm of the intermediate stage is filled with the