RMG 322 Gas pressure regulator

The RMG 372 gas pressure regulator consists of the main valve body on one side and the operating control and safety shut-offs on the other. According to the diaphragm, the final regulation component of the main valve is at the same pressure level. Different diameters of the seat of the valve are open. The purpose of the gas pressure regulator is to monitor the tension in the outlet side of the tube–within certain predefined limits–and to compensate for adjustments in gas consumption and/or inlet stress. There are also a range of multi-size actuators available. Depending on the output level, a pilot may be supplied with or without a separately adjustable auxiliary pressure stage. The pressure difference between the inlet pressure pu and the outlet pressure pd gives auxiliary power to the actuator. Change the auxiliary power to change the stationary amplification by changing the fuel pressure regulator to the

The RMG 408 gas pressure regulator consists of the actuator board, the working “command unit” and the “SAV” toggle. The control unit is composed of an actuator and an actuator and the filter regulator is connected. After the screws are loosened, the working modules can be separated from the actuator shell. This includes a separate maintenance facility. At the measurement location, the starting point for pressure reduction is recorded and fed to the operator via a measuring sequence. The diaphragm in the controller 7 senses the actual value of the output pressure and compares it to the value of the spring force defined (adjustable comparison variable). In this example, the opening of the actuator to adjust the production pressure (actual value) is adjusted by changing the pressure changes to the optimum value of the regulation deviations. The device shuts down safely with no usage. The actuator is fitted with

The RMG 610 is one of the SERIE 600 Gas Pressure Regulator Pilot Units. In the RMG 610 unit, the flow control valve begins with the inlet pipe dia. The DN 200 and upwards are designed for axial flow and therefore the protection shut-off valve can not be used. The approved valve sleeve system is used to provide full relief of inlet and outlet pressure. The valve closure in the valve cone guarantees a bubble-tight shut-off of the process. The electronic actuator rotates the valve sleeve by rotating the worm wheel, which then turns the sleeve with the gear wheel connected to the valve sleeve. If you need a different model other than those listed, please contact us at contact@ittcontrols.com. RMG

The RMG 530-P flow control valve works with electronically controlled flow or pressure control. As the valve sleeve and extension sleeve only need to be removed from the body, RMG 530-P the central valve is easily maintained. The valves are controlled by the inlet pipe dia.DN 200 and upwards are for axial flow and therefore a safety shut-off valve can not be used.If you need a different model other than those listed, please contact us at contact@ittcontrols.com. DN 80/80 l DN 100/100 l DN 150/150 l DN 200/200 l DN 250/250 l DN 300/300RMG